Sinterit PA12 Smooth Print Ready Powder 2KG

$ 300.00

$ 300.00

Sinterit PA12 Smooth PRINT READY Powder ONLY for first-use printing

A Polyamide 12 powder (nylon) for use with Sinterit Printers with good mechanical properties and excellent surface resolution, suitable for high-temperature applications and parts that need to tolerate heat.

Note: Sinterit products must be purchased from your regional distributor. See Ultimate 3D Printing Store's Sinterit Distribution region below. If you are not within this region, please reach out to Sinterit directly at, or use Sinterit's contact form.


Print Ready powder is intended to be used only for the first print in a new Sinterit 3D printer. After your first print you will refresh the used powder with Smooth Fresh Powder each time you print. You should not need additional Print Ready powder (unless you are starting an entirely new print sequence using only Print Ready powder).

To reuse leftover PA12 powder (for your next print) you need to add 22% of Sinterit PA12 Smooth V2 FRESH Powder. Mixed USED powder with FRESH to create PRINT READY powder.


  • good quality-to-price ratio
  • excellent quality print surface and details
  • high chemical resistance


  • Functional prototypes
  • Final product
  • Detailed printouts
  • Complex spatial shapes
  • Temperature resistant objects
  • Chemical resistant objects


  • Manufacturer
  • Brand
  • Granulation
    18 - 90 μm
  • Weight / Volume
    2 kg / 4 L
  • Material type
    PA12 Nylon powder

Reusing the powder in a simple and cost-efficient way

What is the refresh rate?

It is the ratio of a minimum amount of fresh powder needed in a mixture of material used in an SLS 3D printer. A lower refresh ratio means better cost-efficiency of the material.

powder ratio

How it works

The amount of needed fresh powder is automatically calculated by our software and shown on the printer screen after the print job is finished. Just add shown amount of material into the mixing cycle of used material and you can start your next job with refreshed material.

To start SLS 3D printing you need the powder starter pack. After that, you’ll only need to refresh the powder you own with fresh powder.

powder refresh

Ultimate 3D Printing Store's Sinterit Sales Region

The Ultimate 3D Printing Store can only sell Sinterit products within the following US States:

  • Alabama
  • Florida
  • Georgia
  • South Carolina

If you are not within this region, please reach out to Sinterit directly at, or use Sinterit's contact form.

Recently Viewed Products