Phrozen Wax-Like Resin - Easy to Print & Cast Phrozen Wax-Like Resin - Easy to Print & Cast

$ 90.95

-
+
$ 90.95
Add to wishlist

Specification & Performance

Weight: 500g per bottle

XY Resolution: 0.047 mm

Layer Height / Parameter: 12 sec @ 50 um, Delay 2

Way to Clean Printed Part: Use alcohol spray to clean models and dry it by air gun. Do not immerse printed part into alcohol over 30 sec.

Compatible Printer: Phrozen Shuffle, Shuffle XL, Make ParaLED, Make XL ParaLED

Application: Lost-wax Casting for Jewelry & Dental

Key Performance:

Viscosity: 680 mPa.S (25C)

Density: 1.21 g / cm3

Hardness: Shore 65D

Safety Recommendation

​​Do your best to wear glove, goggles, long sleeves shirt during usage of resin. Wash hands after every operation.

​​DO NOT swallow resin. Go to hospital if you do it.

​​Avoid eye contact by resin. Rinse with water and go to hospital if resin contacts eyes.

​​Resin might cause slight skin irritation. Stop using it if allergy occurred.

Resin smells. We strongly suggest you to use it under ventilated condition.

Keep resin in room temperature(15 - 35 Celsius) and dry condition.

Keep resin away from kid.

 

 

About Resin Operation

Avoid sun light exposure.

After printing, stored used resin in closed and opaque bottle. ​​

DO NOT mix fresh resin and used resin.

Shake or stir resin properly to avoid pigment separation.

​​DO NOT dump resin. Please cured resin and treat/recycle it as general plastics garbage.



Specification & Performance

Weight: 500g per bottle

XY Resolution: 0.047 mm

Layer Height / Parameter: 12 sec @ 50 um, Delay 2

Way to Clean Printed Part: Use alcohol spray to clean models and dry it by air gun. Do not immerse printed part into alcohol over 30 sec.

Compatible Printer: Phrozen Shuffle, Shuffle XL, Make ParaLED, Make XL ParaLED

Application: Lost-wax Casting for Jewelry & Dental

Key Performance:

Viscosity: 680 mPa.S (25C)

Density: 1.21 g / cm3

Hardness: Shore 65D

Safety Recommendation

​​Do your best to wear glove, goggles, long sleeves shirt during usage of resin. Wash hands after every operation.

​​DO NOT swallow resin. Go to hospital if you do it.

​​Avoid eye contact by resin. Rinse with water and go to hospital if resin contacts eyes.

​​Resin might cause slight skin irritation. Stop using it if allergy occurred.

Resin smells. We strongly suggest you to use it under ventilated condition.

Keep resin in room temperature(15 - 35 Celsius) and dry condition.

Keep resin away from kid.

 

 

About Resin Operation

Avoid sun light exposure.

After printing, stored used resin in closed and opaque bottle. ​​

DO NOT mix fresh resin and used resin.

Shake or stir resin properly to avoid pigment separation.

​​DO NOT dump resin. Please cured resin and treat/recycle it as general plastics garbage.



Recently Viewed Products Recently Viewed Products