Plated Wear Resistant HeatBreak - 1.75mm - Micro Swiss Plated Wear Resistant HeatBreak - 1.75mm - Micro Swiss

$ 16.00

-
+
$ 16.00
Add to wishlist

This heat break is a direct replacement for use in E3D v6 1.75mm hot ends.

This tube made from stainless steel and plated with TwinClad XT coating. TwinClad XT is a very low friction Electroless Nickel composite coating, often used in injection molding because of it release properties. This high lubricity plating will prevent clogging in the critical zone of hotend, where filament liquidizes. It is also very hard and corrosion resistant. Great for high abrasion filaments like Carbon Fiber, Metal filled, Aluminates, etc.

Made in USA by Micro Swiss

Fits:

- E3D v6 1.75mm Direct and Bowden HotEnds

Dimension:

- Thread size on heater block side : M6x1

- Thread size on heatsink side: M7x1

- Stepped inside bore to improve PLA printing

This heat break is a direct replacement for use in E3D v6 1.75mm hot ends.

This tube made from stainless steel and plated with TwinClad XT coating. TwinClad XT is a very low friction Electroless Nickel composite coating, often used in injection molding because of it release properties. This high lubricity plating will prevent clogging in the critical zone of hotend, where filament liquidizes. It is also very hard and corrosion resistant. Great for high abrasion filaments like Carbon Fiber, Metal filled, Aluminates, etc.

Made in USA by Micro Swiss

Fits:

- E3D v6 1.75mm Direct and Bowden HotEnds

Dimension:

- Thread size on heater block side : M6x1

- Thread size on heatsink side: M7x1

- Stepped inside bore to improve PLA printing

Recently Viewed Products Recently Viewed Products

Liquid error: Could not find asset snippets/zopim.liquid